Reproduced from "David Western's Portland Eisteddfod Lovespoon Blog"
Here it is, the walnut board from which the Eisteddfod spoon will emerge!
Although it doesn't look like much at the moment, especially covered in dried glue, flecks of old paint and the dust of a century and a half, I am very confident there is a spectacular spoon waiting inside.
As you can see, there are a number of holes scattered around the board which were where big screws or nails were driven through the old cabinet holding it to the wall. I have found two or three different areas of this piece where the spoon will fit without running into a hole, so now I just have to settle on the one I think will yield the sweetest grain figure. Right now, I'm leaning heavily to using the wood nearest the edge of the board as it has a section of swirling grain which should line up right where I want the bowls to be. That will make the carving a bit trickier in this area, but will make spectacular bowls which should shimmer as light passes over them.
This wood has something of a history the condensed version I will relate. Apparently, the wood forms the back panels of a wonderful bar which originally was built approximately 150 years ago for a steam ship which traversed the seas between Ireland, the UK and Europe. When the ship was scrapped, the bar was removed and spent many years in a small town pub in Ireland. A number of years ago the bar was purchased by a large hotel in Victoria BC who have now used it as the centerpiece of their off-license shop. The back panels were unnecessary during installation and were scrapped. Fortunately for me and whoever gets this spoon, the pieces were retrieved from the dumpster and found their way to me, where they found a very warm welcome and the opportunity for a new life.
I can't wait to see how this lovespoon turns out!
Here it is, the walnut board from which the Eisteddfod spoon will emerge!
Although it doesn't look like much at the moment, especially covered in dried glue, flecks of old paint and the dust of a century and a half, I am very confident there is a spectacular spoon waiting inside.
As you can see, there are a number of holes scattered around the board which were where big screws or nails were driven through the old cabinet holding it to the wall. I have found two or three different areas of this piece where the spoon will fit without running into a hole, so now I just have to settle on the one I think will yield the sweetest grain figure. Right now, I'm leaning heavily to using the wood nearest the edge of the board as it has a section of swirling grain which should line up right where I want the bowls to be. That will make the carving a bit trickier in this area, but will make spectacular bowls which should shimmer as light passes over them.
This wood has something of a history the condensed version I will relate. Apparently, the wood forms the back panels of a wonderful bar which originally was built approximately 150 years ago for a steam ship which traversed the seas between Ireland, the UK and Europe. When the ship was scrapped, the bar was removed and spent many years in a small town pub in Ireland. A number of years ago the bar was purchased by a large hotel in Victoria BC who have now used it as the centerpiece of their off-license shop. The back panels were unnecessary during installation and were scrapped. Fortunately for me and whoever gets this spoon, the pieces were retrieved from the dumpster and found their way to me, where they found a very warm welcome and the opportunity for a new life.
I can't wait to see how this lovespoon turns out!
No comments:
Post a Comment